Skip to content

Research and development

Advanced manufacturing research and development

We develop composite armour, advanced materials and the machines that make them, from concept through test to equipment deployed in the field. The aim is lower mass, stronger multi-hit protection and manufacturing capability where it is needed.

How development runs

Three development stages, from material concept to field use

We carry a programme through three stages, with a decision gate between each. You can join at whichever stage your programme has reached, and we can take it to a tested part, a machine or a deployed capability.

  1. 01Define

    Concept and materials research

    • Target set: mass, threat or load case, geometry
    • Lattice and composite concepts modelled
    • Early coupons printed and characterised
  2. 02Prove

    Prototype and test

    • Full-size prototypes built in days
    • Test plans written with partners and laboratories
    • Geometry and material revised from results
  3. 03Deploy

    Field trial and production

    • Rugged equipment taken to the point of use
    • Repeatable process and build records
    • Production route handed over or run by us

Machine design and in-field manufacturing

Machine and equipment design

New materials and processes often need equipment that does not yet exist. We design bespoke printer frames, robotic cells, fixtures and test rigs, and package them so manufacturing can happen where it is needed: at a base, a site or the point of repair.

ELEVATION, SIDE WALL REMOVED1234560582591PLANDOUBLE DOOR6058CELL CONTENTS (EXAMPLE)1LARGE-FORMAT PRINTER2ROBOT ARM, FINISHING3FEEDSTOCK RACKS4POWER + CONTROL5FILTERED EXTRACTIONDEPLOYMENT (EXAMPLE)FORM20 FT CONTAINER, ROAD-TRANSPORTABLEPOWERMAINS OR GENERATORSET-UPHOURS ON LEVEL HARDSTANDINGOUTPUTREPAIR PARTS, FIXTURES, TOOLINGTITLEMANUFACTURING CELLHP3D-RD-CELL-01 REV A20 FT ISO CONTAINER · ILLUSTRATIVESCALE NTSSHEET 1 OF 1

Example use case: a drawing that shows how a deployable cell is laid out. It illustrates the kind of machine design we undertake and is not a delivered product.

Programme areas

Materials science

We research composite armour materials and use additive manufacturing to make them. The focus is strength-to-weight ratio and multi-hit capability.

Applications
Air and land
Targets
Strength-to-weight, multi-hit
Route
Prototype, test, revise

Digital fabrication

Lattice structures and generative design reduce the mass of ballistic plates and vehicle panels. The design aim is more energy absorbed per unit mass than a solid plate.

Methods
Lattice design, generative design
Parts
Plates, vehicle panels

Automation

Robotic assembly is used for composite layering where positional repeatability matters, for example in personal protection and drone chassis.

Use
Composite layering
Applications
Personal protection, drone chassis

Machine design

We design the equipment a new process needs: bespoke printer frames, robotic cells, fixtures and test rigs, built and proven alongside the material or part they serve.

Scope
Printer frames, robotic cells, fixtures, test rigs
Route
Concept, build, commission, hand over

In-field manufacturing

Ruggedised printing units placed near the point of use allow repair of vehicle components and custom-fit protection without a long supply line.

Use
On-demand repair
Aim
Shorter logistics chain

How a material concept is developed

  1. 01

    Concept

    Define the target: mass, threat or load case, geometry.

  2. 02

    Prototype

    Print the lattice or composite concept quickly.

  3. 03

    Test

    Test against the target with partners where required.

  4. 04

    Revise

    Change geometry and material from the results.

Develop a material concept into a tested part

Describe the application and we will say how we would approach it.